Alert rule for stack member

Help
1

Hello,

i have n°3 Cisco 3750G in Stack configuration (one management IP); is possible to create a rule to monitoring each single switch, stack member, and receive email if one of these is down?

Thanks

2

Hello Lycos,

Yes, you can monitor the “state” of the stacks and create alerts when they change or fail. I have a Cisco 6800 VSS stack that shows these state, and you can track any change here. Cisco 3750G show equivalent states that you can use.

54

PipoCanaja

3

Hi, PipoCanaja
sorry, but in the state I only view “fan” and “power supply” status of the 3 switch; in ‘inventory’ librenms indicate “Cat37xx Stacking” and I view the single serial number/model of the member stack.

How can I monitorate the health status of the member? (in alert editing is there any ‘sensor type’ for this?)

Thanks!

4

Hello

Here is a capture of a 2 members stack of 3750G :

3750G
3750G659×527 15.3 KB

Sensor discovery and polling must be enabled. port-stack discovery is also enabled on mine but I have no clue if it is related or not (in doubt, you can enable it).