This request is created because “The Neil” said so, in this issue: netscaler-vsvr not finding the vservers · Issue #2413 · librenms/librenms · GitHub
In short, i have a netscaler SDX, with virtual load balancers that both run 10.5 and 11. I’m missing my vservers graphs.
I’ll provide anything you need. Even beer.
Good old rubberduck debugging.
Even though i have the “$config[‘poller_modules’][‘netscaler-vsvr’] = 1;” set in my config.php - the netscalers I add doesn’t get the “load balancer” tab.
I have to enable the module under each device for it to show up.
I don’t know if it’s based on OS detection, but i’m leaving this post for future googlers.